Rapid Prototype China Mold Industry News

isRoot = "true">

In recent years, stable and rapid economic development, encouraging the rapid growth in fixed assets investment, China Mould market demand. As the industry improve its competitiveness and national policy support, domestic plastic mold industry output value and sales revenue for many years maintained a growth rate of 20%. Die and Mould Technology, Shenzhen Institute of Deputy Secretary General Luo Baihui Dongguan Daily News recently was the latest happenings in the mold industry.

Auto IT electronics industry mold market economy, the impact of development

China imported the first negative growth of mildew, mold industry, "one large and one small" pull, developing very well in the last two years. "Large" refers to the automotive industry, automotive industry refers not only to vehicles and automotive parts, such as the United States has now become China's first second-largest auto-parts exporter, which means that China's Auto Market mold has played irreplaceable role. Its rapid development of mold plays an important role in driving the "small" refers to the industry of electronics. Total imports in 2006, Die $ 20.47 billion $ 2.068 billion in 2005 decreased $ 21 million for the first time negative growth, halted the momentum expansion of imports increased every year, exports totaled $ 1.041 billion, more odporast from 41.06 percent in 2005 for the first time more than $ 10 billion, and imports cut the deficit down, is very satisfactory.

Die necessary to further adjust the industrial structure of the

While the mold industry in previous years made ​​significant progress, but there are still many problems. For example, the phenomenon of irrational industrial structure still exist. The structure, including product mix, technological structure, the structure of exports, there are varying degrees of problems. For example, in the structure of imports and exports, due to the mold design and manufacturing standards and capabilities can not meet market demand, therefore, die every year a large number of imports, especially high-end products. In 2006, import and export of stamping die, if the weight, at a cost of $ 14,913 / t and $ 5,869 / tonne, much higher than import export, while the plastic rubber mold, in 2006 imports and exports were 413,715 units, 1217 .772 units, exports far exceed imports, while the device is very different from the poor: the import price of $ 2,532 / set, export price of 602 USD / set, a difference of four times, although exports is almost 3 times the amount of imports, but still below the total amount of imports. Yes we are still importing large quantities of high quality molds, exports dominate the medium and low. Thus, in the long run, rationalization of import and export trends to expand exports and reduce imports, it exports more than imports. Obviously, this also requires some time wanted to do.